QUESTION 104
There are two routes in the routing table:
0 dst-addr=10.1.1.0/24 gateway=5.5.5.5
1 dst-addr=10.1.1.4/30 gateway=5.6.6.6
Which gateway will be used to get to the IP address 10.1.1.6?

QUESTION 105
Which of the following is NOT a valid MAC Address?

QUESTION 106
What does the passive command provide to dynamic routing protocols?

QUESTION 107
What does the firewall action “log” do?

QUESTION 108
Select which of the following are ‘Public IP addresses’:

QUESTION 109
Consider the following network diagram. In R1, you have the following configuration:
/ip route
add dst-address=192.168.1.0/24 gateway=192.168.99.2
/ip firewall nat
add chain=srcnat out-interface=Ether1 action=masquerade
On R2, if you wish to prevent all access to a server located at 192.168.1.10 from LAN1 devices, which of the following rules would be needed?

QUESTION 110
What command is used to create a backup configuration?

QUESTION 111
During a scan, in order to see all the available wireless frequencies that are supported by the card, the following option must be selected in the wireless card’s “Frequency Mode”:

QUESTION 112
Which router command allows you to view the entire contents of all access lists?

QUESTION 113
Which of the protocols below is used by Netinstall?

QUESTION 114
Which firewall chain would be used to block a client’s MSN traffic on a router?

QUESTION 115
What does the firewall action “Redirect” do? Select all true statements.

QUESTION 116
When backing up your router by using the ‘Export’ command, the following happens:

QUESTION 117
Consider the following diagram. We want to communicate from a device on LAN1 to a device on LAN2.
Assuming that all necessary configurations are already included on R2, which of the following configurations in R1 would enable this communication?

QUESTION 118
Choose all valid hosts address range for subnet 15.242.55.62/27

QUESTION 119
Which of the following protocols / port s are used for SNMP. (Simple Network Managemnt Protocol)

QUESTION 120
If you use either Telnet or FTP, which is the highest layer you are using to transmit data?

QUESTION 121
You have a DHCP server on your MikroTik router. The IP addresses 10.1.2.2-10.2.2.20 are distributed in the DHCP network. Additionally, 3 static IP address are defined for your servers: 10.1.2.31-10.1.2.33.
After a while 20 more IP addresses need to be distributed in the network. It is possible to distribute the extra IP address without adding another DHCP Server:

QUESTION 122
There are two wireless cards (wlan1 and wlan2) which are bridged together. On wlan1 card there is a setting
“Forwarding=no”. Choose the correct answer(s):

QUESTION 123
Mark all correct answers.

QUESTION 124
Firewall NAT rules process only the first packet of each connection.

QUESTION 125
What layer in the TCP/IP stack is equivalent to the Transport layer of the OSI model?

QUESTION 126
What is a stub network?

QUESTION 127
The network address is