Q265. Refer to the exhibit.

An engineer configures SW101 to send OSPFv3 interfaces state change messages to the server. However, only some OSPFv3 errors are being recorded. which organization resolves the ..?

Q266. Drag and drop the operations from the left onto the locations where the operations are performed on the right.

Q267. Drag and drop the MPLS concepts from the left onto the descriptions on the right.

Q268. Refer to the exhibit.

An engineer is troubleshooting a failed Telnet session from PC to the DHCP server. Which action resolves the issue?

Q269. Refer to the exhibit.

What is the result of applying this configuration?

Q270. Drag and drop the MPLS terms from the left onto the correct definitions on the right.

Q271. Refer to the exhibit.

User in the branch network of 2001. db8 0.4 report they cannot access the internet.
Which command is issued in IPv6 router EIGRP 100 configuration mode to solve this issue?

Q272. Refer to the exhibit.

An engineer must configure a LAN-to-LAN IPsec VPN between R1 and the remote router. Which IPsec Phase 1 configuration must the engineer use for the local router?

Q273. Refer to the exhibit.

An engineer is monitoring reachability of the configured default routes to ISP1 and ISP2. The default route from ISP1 is preferred if available. How is this issue resolved?

Q274. Refer to the exhibit.

Drag and drop the credentials from the left onto the remote login information on the right to resolve a failed login attempt to vtys. Not all credentials are used

Q275. Refer to the exhibit.

Which control plane policy limits BGP traffic that is destined to the CPU to 1 Mbps and ignores BGP traffic that is sent at higher rate?

Q276. Which of the following statements are true regarding two EIGRP routers to become neighbors?

Q277. Refer to the exhibit.

An engineer configures the router 10.1.100.10 for EIGRP autosummarization so that R1 should receive the summary route of 10.0.0.0/8. However, R1 receives more specific /24 routes.
Which action resolves this issue?

Q278. Refer to the exhibits.

When DMVPN is configured, which configuration allows spoke-to-spoke communication using loopback as a tunnel source?

Q279. Drag and drop the SNMP attributes in Cisco IOS devices from the left onto the correct SNMPv2c or SNMPV3 categories on the right.

Q280. Which two site-to-site tunnel-based VPN technologies support routing, multicast and private IP addressing?
(Choose two.)

Q281. The network administrator is tasked to configure R1 to authenticate telnet connections based on Cisco ISE using RADIUS. ISE has been configured with an IP address of 192.168.1.5 and with a network device pointing towards R1 (192.168.1.1) with a shared secret password of Cisco123. If ISE is down, the administrator should be able to connect using the local database with a username and password combination of admin/cisco123.
The administrator has configured the following on R1:
aaa new-model
!
username admin password cisco123
!
radius server ISE1
address ipv4 192.168.1.5
key Cisco123
!
aaa group server tacacs+ RAD-SERV
server name ISE1
!
aaa authentication login RAD-LOCAL group RAD-SERV
ISE has gone down. The Network Administrator is not able to Telnet to R1 when ISE went down.
Which two configuration changes will fix the issue? (Choose two.)

Q282. Refer to the exhibit.


An engineer identifier a Layer 2 loop using DNAC. Which command fixes the problem in the SF-D9300-1 switch?