NEW QUESTION 110
You are reviewing a series of MSA2052 storage designs for a customer’s remote locations. Their largest
remote site requires the highest possible level of internal data protection with at least 20 TB of storage. Which disk drive design is adequate for this site?

NEW QUESTION 111
A customer plans to back up a file server that holds 2 TB of dat
a. The customer wants to upgrade their network infrastructure to support backup and to implement a datacenter network solution.
Which solutions would HPE recommend to meet the customer needs? (Choose two.)

NEW QUESTION 112
A customer needs a Layer 2 switch that provides basic switch functionality without the need to use a CLI or a GUI. Which type of switch meets the customer’s needs?

NEW QUESTION 113
Read the question, and then refer to the exhibit.
<Switch-A>display interface Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state: Administratively DOWN Line protocol state: DOWN IP packet frame type: Ethernet II, hardware address: d894-03fb-793d Description: Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK_SFP_PLUS Unknown-speed mode, unknown-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100% Multicast max-ratio: 100% Unicast max-ratio: 100% PVID: 1 MDI type: Automdix Port link-type: Trunk VLAN Passing: 10, 20 VLAN permitted: 10, 20 Trunk port encapsulation: IEEE 802.1q Port priority: 0 Last link flapping: 0 hours 0 minutes 18 seconds Last clearing of counters: Never Peak input rate: 78 bytes/sec, at 2011-03-31 04:55:57 Peak output rate: 15 bytes/sec, at 2011-03-30 23:00:57 Last 300 second input: 0 packets/sec 67 bytes/sec – % Last 300 second output: 0 packets/sec 14 bytes/sec – % Input (total): 62670 packets, 8565340 bytes 0 unicasts, 0 broadcasts, 62670 multicasts, 0 pauses Input (normal): 62670 packets, – bytes 0 unicasts, 0 broadcasts, 62670 multicasts, 0 pauses Input: 0 input errors, 0 runts, 0 giants, 0 throttles 0 CRC, 0 frame, – overruns, 0 aborts – ignored, – parity errors Output (total): 3707 packets, 1294835 bytes 0 unicasts, 0 broadcasts, 3707 multicasts, 0 pauses Output (normal): 3707 packets, – bytes 0 unicasts, 0 broadcasts, 3707 multicasts, 0 pauses Output: 0 output errors, – underruns, – buffer failures 0 aborts, 0 deferred, 0 collisions, 0 late collisions 0 lost carrier, – no carrier A customer added a new switch to their network. They connected it using interface Ten-GigabitEthernet 1/0/1. They are using VLAN 10 and 20 for the devices in their network.
The new switch was fully operational. Then, the customer experienced a power failure later that day and could not reach any device on the new switch after the power returned.
From the output in the exhibit, would could be the issue?

NEW QUESTION 114
A customer has a small business office and is concerned that the local storage in their current ProLiant Gen 10 server with a Linux OS Is reaching maximum capacity Which solution should you recommend to expand the customers data storage capacity?

NEW QUESTION 115
Refer to the exhibit.

You are validating a Nimble HF40 configuration created in OCA, and you receive an error when you run a CLIC check.
Which Nimble component needs to be added to the configuration to complete the solution?

NEW QUESTION 116
Match each characteristic to the correct storage type.

NEW QUESTION 117
Match each customer data center architecture to its network topology.

NEW QUESTION 118
A customer needs to update a server’s firmware using the latest Support Pack for ProLiant (SPP). They use a bootable USB flash drive to do so, and they select Interactive Mode on boot. Once the device boots, they are unsure how to proceed and ask for your assistance.
What can you tell them to do to easily update the firmware?

NEW QUESTION 119
A customer has requested that you provide them with an architecture and bill-of-materials for a stack of top-of- rack switches. The customer has 34 HPE DL360 servers in the rack, each with four 1GBASE-T Ethernet ports which need to be connected to the network.
The customer is upgrading 50% of the 1GBASE-T Ethernet ports on the servers to 10GBASE-T Ethernet ports and needs the switching to support the upgraded servers. They are opposed to a chassis switch, and want to keep the number of managed devices on the network to a minimum.
Which architecture meets the customer requirements?

NEW QUESTION 120
Which series of internal checks will an HPE ProLiant server use to validate that the base hardware components are working correctly before booting the operating system?

NEW QUESTION 121
A client complains about systems reliability issues caused by their staff’s inability to identify the root cause of failures. The client’s lead administrator wants to automatically send data from HPE OneView to additional listeners in the network.
What should you configure in HPE OneView to enable the external monitoring of the managed devices?

NEW QUESTION 122
A security client needs a surveillance solution to support 239 Cameras. They expect to generate 2PB of data and require a 10Gb network infrastructure in a single rack.
Which solution should you recommend to meet the customer requirements?

NEW QUESTION 123
Refer to the exhibit.

The information shown is displayed for a Nimble array you are installing. The customer’s administrator has asked you for the speed at which the Nimble ports are connecting to their SAN switches, and you have run the command shown to determine the number of gigabits per second used by this port connection.
What speed does the exhibit indicate is in use?

NEW QUESTION 124
Match each customer data center architecture to its network topology.

NEW QUESTION 125
What connection type is identified by the following address type? B4-D5-BD-9F-0A-C3

NEW QUESTION 126
Refer to the exhibit.

A customer has been using VEEAM and the HPE StoreOnce 3620 shown in the exhibit to backup their environment. The customer’s legal team has asked to double their retention times for all backup sets, and they are starting to run out of space on the StoreOnce.
Which options could you recommend that the customer add to their existing configuration to accommodate the new requirement? (Select two. Each option represents a separate solution.)

NEW QUESTION 127
Indicate whether each management feature manages or monitors a single system or multiple systems.

NEW QUESTION 128
A client complains about systems reliability issues caused by their staff’s inability to identify the root cause of failures. The client’s lead administrator wants to automatically send data from HPE OneView to additional listeners in the network.
What should you configure in HPE OneView to enable the external monitoring of the managed devices?