Download Exam CFPE Practice Test Questions with 100% Verified Answers [Q55-Q79]

admin February 21, 2025 0 Comments

4.5/5 - (6 votes)

Download Exam CFPE Practice Test Questions with 100% Verified Answers

Share Latest CFPETest Practice Test Questions, Exam Dumps

Q55. Which one of the following statements is true when requirements differ between NFPA1 and a referenced document?

NFPA1 requirements are enforced

The referenced document’s requirements are enforced

The more restrictive requirements ate enforced

The board of appeals determines which requirements to enforce

Q56. How many fire hydrants are located on the project site on plan L2?

Zero

One

Two

Three

Q57.

What is the occupant loadof the cafetorium on plan A5 if me room is set up for a less concentrated use without fixed seating’?

184

251

394

Q58. Which of the following is the preferred method when determining measurements on drawings?

Use an architect’s scale to measure directly from the drawing

Use the dimensions given on the drawing

Use the indirect method of measurement

Calculate the length from other dimensions

Q59. Exhibit.

On plan A7, what is the corridor floor finish for the first floor plan wing C?

Parinted concrete

Ceramic tile

NewVCT

Carpel

Q60. Exhibit.

Based on site plan C1 of the plan set what is the maximum depth the water lines are to be buried”

4 ft(1.2 m)

5 ft (1.5 m)

6 ft (1.8 m)

7 ft (2.1 m)

Q61. Exhibit.

What is the minimum required distance between the two exits, if the assembly occupancy pictured is not sprinklered?

21.5 ft (6.5 m)

42.5 ft (13 m)

62.5 ft (19 m;

81.5 ft (24.8 m)

Q62. Which one of the following is a right given to a board of appeals?

The right to waive code requirements

The right to set jurisdiction precedent

The right to withdraw a project

The right to grant alternative methods

Q63. Which one of the following is a valid condition that would permit a person to appeal a decision of an authority having jurisdiction’?

The provisions of the code do not fully apply

The decision causes a financial hardship

The authority having jurisdiction has a personal interest in the decision

The authority having jurisdiction did not follow established procedures

Q64. What is the duration of the fire flow for a kindergarten center of 150.000 ft2 (13.935 m2) of Type II (111) construction?

1 hour

2 hours

3 hours

4 hours

Q65. Exhibit.

On plan F2.0. the fire sprinklers in playroom A14 are supplied by what size cross main?

1 in (25 mm)

1 1/4 in (32 mm)

2 1 2 m (64 mm)

3 in (76 mm)

Q66. Exhibit.

What is the approximate maximum available water indicated on supply graph 2 on plan F0.2?

980 gpm (3,709 Ipm)

1,680 gpm (6,359 Ipm)

1.980gpm (7,495 Ipm)

3,980gpm(15,066lpm)

The graph labeled as”Water Supply Graph N°2″presents a standard water supply flow test summary, which indicates the relationship between pressure (psi or kPa) and flow (gpm or Lpm) for a specific system or hydrant.
How to interpret the graph:
* Static Pressure:
* This is the pressure measured when there is no water flowing, shown at the highest point on the left side of the graph (indicated as approximately 100 psi or 689 kPa in this case).
* Residual Pressure:
* This is the pressure available when water is flowing at a specific rate. The residual pressure line decreases as flow increases, indicating that the pressure reduces when water is drawn from the system.
* Maximum Available Water:
* Themaximum available wateris the point where the system can deliver the highest possible flow (gpm) before the residual pressure reaches a critical minimum level, indicating the system’s limit.
* Flow at Maximum Available Water:
* In this specific graph, the point marked asMaximum Available Wateris where the flow reaches
1,980 gpm(7,495 Lpm). This is derived by following the flow axis (horizontal axis) until it intersects with theMaximum Available Watercurve on the graph.
Why the Correct Answer is C (1,980 gpm):
* By following the plotted line for residual pressure, the graph shows that the maximum flow attainable from the system is1,980 gpm(7,495 Lpm) before pressure drops too low. This value represents the system’s maximum water supply capacity under normal operating conditions.
This analysis is consistent with the flow rates displayed on the graph and matches the key markers labeled, which indicate the operational limits of the system.
NFPA Relevance:
In fire protection and water supply systems, understanding the maximum available water flow is essential for ensuring that sufficient water can be delivered in the event of a fire. This calculation is particularly relevant in the context of NFPA 20 (Standard for the Installation of Stationary Pumps for Fire Protection) and NFPA 25 (Standard for the Inspection, Testing, and Maintenance of Water-Based Fire Protection Systems), as these standards require that water supply systems are capable of delivering adequate flow to suppression systems under expected fire conditions.

Q67. Exhibit.

What does point “A” on the water supply graph represent?

Maximum available water

Residual pressure

Optimized pressure

Static pressure

Q68. What percentage of wall area may be covered with art work in a sprinklered educational occupancy?

10%

15%

20%

50%

Q69. Which of the following supporting documents is definedas illustrations and descriptions of a system component taken from a manufacturer’s catalog?

Cut sheet

Data sheet

Errata sheet

Calculation sheet

Q70. Actuation of alarm notification appliances at the protected premises shall occur within how many seconds after the activation of an initiating device?

10 seconds

30 seconds

60 seconds

90 seconds

Q71. Plan examiners should be aware of what two basic types of code models’?

Prescriptive and necessary

Prescriptive and variable

Performance and standard

Prescriptive and performance

Q72. What is the maximum common path of travel permitted in a sprinklered educational occupancy?

20 ft (6 m)

75 ft (23 m)

100 ft (30 m)

200 ft (61 m)

Q73. Exhibit.

In the figure what would be the minimum diagonal distance between stairways 1 and 2?

22 ft 4 in (6.8 m)

29 ft 2 in (8.9 m)

37 ft 3 in. (11.3m)

43 ft 9 in (13.3 m)

Q74. Exhibit.

What is the guardrail height for rampS/Stairs shown in plan A5?

1 fl 3 in (38 m)

1 ft 7 m (48 m)

2 fl 10 in (86 m)

3 ft 6 in (1 m)

Q75. What is the maximum floor area on any one floor permitted to be protected by a single sprinkler system riser for an ordinary hazard occupancy?

25,000 ft2 (2,323 m2)

40,000 ft2 (3,716 m2)

50,000 tt2 (4,645 m2)

52,000 ft2 (4,831m2)

Q76. The responsibilities of a Board of Appeals includes which of the following?
I). Interpreting the codes
II). Reviewing alternative methods and procedures
III). Ruling on challenges to the building or fire official regarding the applicability and interpretation of the codes
IV). Evaluating alternative proposals for compliance with the codes

II and III

II, III. and IV

I, II, III, and IV

Q77. Exhibit.

Based on the figure, what is the total width of exiting required?

3,100 in (78.740 mm)

4,650 in (118100 mm)

6,200 in (157 500 mm)

7,750 m (196 800 mm)

Q78. What is the minimum rating for visible indicating appliances in corridors’?

10 cd

15 cd

20 cd

25 cd

Q79. Exhibit.

Which of the following best describes the location of the manual pull station on plan A12?

On the north wall adjacent to the cafeteria exit doorway

On the east wad adjacent to the pot sinks

On the south wall adjacent to the Ansel agent tank

On the west wall adjacent to the handwash sink

Positive Aspects of Valid Dumps CFPE Exam Dumps!: https://www.vcedumps.com/CFPE-examcollection.html

Download Exam CFPE Practice Test Questions with 100% Verified Answers [Q55-Q79]

Leave a Reply Cancel reply

CFPE Practice Tests

Related Certifications

Recent Posts

Categories

Archives