Q29. An administrator needs to deploy managed FortiSwitch devices in a remote location where multiple VLANs must be utilized to segment devices. No Layer 3 switch or router is present. The the only WAN connectivity is the router provided by the ISP connected to the public internet.
Which two items will the administrator need to use? (Choose two.)

Q30. Which statement about the use of the switch port analyzer (SPAN) packet capture method is true?

Q31. Refer to the exhibit.

The exhibit shows the current status of the ports on the managed FortiSwitch. Access-1.
Why would FortiGate display a serial number in the Native VLAN column associated with the port23 entry?

Q32. Which Ethernet frame can create Layer 2 flooding due to all bytes on the destination MAC address being set to all FF?

Q33. Which interfaces on FortiSwitch send out FortiLink discovery frames by default in order to detect a FortiGate with an enabled FortiLink interface?

Q34. What can an administrator do to maintain the existing standalone FortlSwltch configuration while changing the management mode to FortLink?

Q35. Which two statements about DHCP snooping enabled on a FortiSwitch VLAN are true? (Choose two.)

Q36. Refer to the exhibit.

What two conclusions can be made regarding DHCP snooping configuration? (Choose two.)

Q37. Exhibit.

What conditions does a FortiSwitch need to have to successfully configure the options shown in the exhibit above? (Choose two.)

Q38. Which statement about the quarantine VLAN on FortiSwitch is true?

Q39. How is traffic routed on FortiSwitch?

Q40. Refer to the exhibit.

Which two statements best describe what is displayed in the FortiLink debug output shown in the exhibit? (Choose two.)

Q41. How does FortiSwitch perform actions on ingress and egress traffic using the access control list (ACL)?

Q42. Exhibit.

port24 is the only uplink port connected to the network where access to FortiSwitch management services is possible. However, FortiSwitch is still not accessible on the management interface. Which two actions should you take to fix the issue and access FortiSwitch? (Choose two.)

Q43. Which LLDP-MED Type-Length-Values does FortiSwitch collect from endpoints to track network devices and determine their characteristics?

Q44. Which drop policy mode, if assigned to a congested port, will drop incoming packets until there is no congestion on the egress port?

Q45. Exhibit.

Two routes are not installed in the forwarding information base (FIB) as shown in the exnibit. Which two statements about these two route entries are true? (Choose two.)

Q46. Exhibit.

port24 is the only uplink port connected to the network where access to FortiSwitch management services is possible. However, FortiSwitch is still not accessible on the management interface. Which two actions should you take to fix the issue and access FortiSwitch? (Choose two.)

Q47. Which statement about the IGMP snooping querier when enabled on a VLAN is true?

Q48. Exhibit.

LAG and MCLAG are used to increase the available network bandwidth and enable redundancy. How does spanning tree protocol see MCLAG and LAG if they are configured based on the physi-cal view shown in the exhibit? (Choose two)

Q49. What can an administrator do to maintain the existing standalone FortlSwltch configuration while changing the management mode to FortLink?

Q50. How does FortiGate handle configuration of flow tracking sampling if you export the settings to a managed FortiSwitch stack with sampling mode set to perimeter is true?

Q51. FortiGate is unable to establish a tunnel with the FortiSwitch device it is supposed to manage Based on the debug output shown in the exhibit, what is the reason for the failure?

Q52. Which statement about the IGMP snooping querier when enabled on a VLAN is true?