NO.149 In an SD-WAN architecture, which methods are used to bootstrap a vEdge router?

NO.150 Refer to the exhibit.

Refer to the exhibit. An engineer is planning an IPv4 to IPv6 migration solution for a customer. The routers in the network can support IPv4 and IPv6, except for the DWDM routers. The DWDM routers provide a Layer 2 link in which the routers peer directly with each other across a DWDM circuit. The circuit also provides connectivity between the mail servers. Which IPv6 migration technique must the engineer deploy?

NO.151 Which three ways are SD-Access and ACI Fabric similar? (Choose three.)

NO.152 Which two routing protocols allow for unequal cost load balancing? (Choose two.)

NO.153 How are wireless endpoints registered in the HTDB in a Cisco SD-Access architecture?

NO.154 Which two considerations must be made regarding the overlay network for a Cisco SD-Access architecture?
(Choose two.)

NO.155 An engineer is working with NETCONF and Cisco NX-OS based devices.
The engineer needs a YANG model that supports a specific feature relevant only to Cisco NX- OS.
Which model must the engineer choose?

NO.156 An engineer is working for a large cable TV provider that requires multiple sources streaming video on different channels using multicast with no rendezvous point.
Which multicast protocol meets these requirements?

NO.157 A router running ISIS is showing high CPU and bandwidth utilization. An engineer discovers that the router is configured as L1/L2 and has L1 and L2 neighbors. Which step optimizes the design to address the issue?

NO.158 What is the easiest way to enable SD-Access for all your remote sites after you have your campus SD-Access fabric up and running?

NO.159 A company must automate a set of complex changes aligned with DR testing in the network. These changes are specific, and the DR playbook will be adjusted in the future. The playbook has diverse routing and switching assets in scope as well as multiple vendor and hardware platforms. A developer will create a thin, web front-end microservice and integrate with an Open daylight controller to push changes to the network.
Which YANG model should be used?

NO.160 Which OSPF area blocks LSA Type 3, 4 and 5, but allows a default summary route?

NO.161 Which method will filter routes between EIGRP neighbors within the same autonomous system?

NO.162 What is the function of the multicast Reverse Path Forwarding check?

NO.163 Drag and Drop Question
Drag and drop the description from the left onto the corresponding WAN connectivity types and categories on the right.

NO.164 An engineer is working for a large cable TV provider that requires multiple sources streaming video on different channels using multicast with no rendezvous point. Which multicast protocol meets these requirements?

NO.165 A router running ISIS is showing high CPU and bandwidth utilization. An engineer discovers that the router is configured as L1/L2 and has L1 and L2 neighbors. Which step optimizes the design to address the issue?

NO.166 Refer to the exhibit. Which two solutions maximize the use of the links between the core and distribution layers? (Choose two.)

NO.167 What is the purpose of the fabric management plane in a Cisco SD-Access architecture?

NO.168 Refer to the exhibit. An architect is designing an EIGRP solution based on these requirements:
– Traffic forwarding should use the best two paths while all links are
available
– Single path failure must not impact traffic between branch and HQ
Which solution must the architect select?

NO.169 Refer to the exhibit. AS65533 and AS65530 are announcing a partial Internet routing table as well as their IP subnets. An architect must create a design that ensures AS64512 become a transit AS. Which filtering solution must the architect choose?

NO.170 Drag and drop the characteristics from the left onto the correct telemetry mode on the right.

NO.171 Refer to the exhibit. An architect is designing an ISIS network for a customer migrating from IPv4 to IPv6. The current network uses narrow metrics, and the IPv6 areas will increase to 10 within the next two years. Also, IPv6 traffic must not blackhole in IPv4 network during the migration.
Which two solutions must the architect choose? (Choose two.)

NO.172 Refer to the exhibit. An architect must design a solution to connect the two ASs. To optimize bandwidth, the design will implement load sharing between router R6 and router R4. Which solution should the design include?

NO.173 An architect must design an IPv6 migration solution for a corporation with remote offices to support:
* The customer has IPv4 peering with their service provider.
* IPv6 users need access to IPv4 and IPv6 resources.
* Existing content providers will migrate to IPv6 in the next two years.
* Users will be migrated in a phase-by-phase approach.
Which migration solution must the architect choose?