NEW QUESTION 41
It is good practice for the NACE Inspector to have instrument calibration certificates available:

NEW QUESTION 42
NACE No. 4/SSPC-SP-7 is a joint standard for

NEW QUESTION 43
Polymerization is the process of:

NEW QUESTION 44
When performing tests for oil and grease using an ultra-violet light, the NACE Inspector should be aware that:

NEW QUESTION 45
A single application coating film has a measured dry film thickness (DFT) between 4 and 5 mils (between 100 and 125 microns). The volume solids of the coating immediately before application were 67%, What wet film thickness (WFT) was applied?

NEW QUESTION 46
Checking is

NEW QUESTION 47
A successful coating inspector must be able to

NEW QUESTION 48
Upon arrival of coating materials, the inspector should

NEW QUESTION 49
An exposed area of the substrate or previous coat of a conductive coating material, often caused by poor application technique is called

NEW QUESTION 50
Common errors that may produce inaccurate readings when using a Dial-Type Magnetic Pull-Off Dry Filth Thickness (DFT) gauge include:
Select All That Apply

NEW QUESTION 51
When holiday testing is required the Inspector is always required to enforce NACE SP 0188:

NEW QUESTION 52
The least effective method of surface cleaning is most likely

NEW QUESTION 53
You are an inspector on a project where SSPC SP 3 is specified.
What sort of tools should you expect the Contractor to use to achieve the standard?

NEW QUESTION 54
An inspectors personal log book should contain:

NEW QUESTION 55
Stripe coats are best applied by:

NEW QUESTION 56
You are the NACE Inspector on a job where ISO ST 3 has been specified. The Contractor normally works to SSPC standards and been referencing SSPC SP 3.
Could this have any impact on the final surface preparation appearance?

NEW QUESTION 57
Solvents are added to coating formulations to

NEW QUESTION 58
Conventional spray is a good choice when:

NEW QUESTION 59
Passivation can best be described as:

NEW QUESTION 60
Which is a component that supplies most of the features and functions of the material?

NEW QUESTION 61
Inspector’s daily reports are used:
Select All That Apply

NEW QUESTION 62
According to SSPC PA 2 a Spot Measurement is: