NO.149 What is the default value (in milliseconds) set for the poll interval in the BFD basic configuration?

NO.150 Drag and drop the devices from the left onto the correct functions on the right.

NO.151 Refer to the exhibit. CSRv1 must redistribute OMP routes into OSPF Area 1 that must be seen as type 7 LSA by RTR1. CSRv1 must also advertise the default route toward RTR1, which is learned via OMP. Which two configurations must the engineer implement to meet these requirements?
(Choose two.)

NO.152 Drag and drop the Cisco SD-WAN components from the left onto their functions on the right.

NO.153 Which VPN connects the transport-side WAN Edge interface to the underlay/WAN network?

NO.154 A customer is receiving routes via OMP from vSmart controller for a specific VPN. The customer must provide access to the W2 loopback received via OMP to the OSPF neighbor on the service-side VPN, which configuration fulfils these requirements?

NO.155 Which configuration changes the packet loss priority from low to highly?
A)

B)

C)

D)

NO.156

Refer to the exhibit Which configuration must the engineer use to form underlay connectivity for the Cisco SD-WAN network?

NO.157 Refer to the exhibit. The SD-WAN network is configured with a default full-mesh topology. The network engineer wants the Rome WAN Edge to use the MPLS TLOC as the preferred TLOC when forwarding Telnet traffic as long as the MPLS link has these characteristics:
Loss: 5%
Latency: 100ms
Jitter: 100 ms
Which configuration must the network engineer use to create a list that that classifies the MPLS link characteristics?

NO.158 In which device state does the WAN edge router create control connections, but data tunnels are not created?

NO.159

An engineer configures Rome WAN Edge 10 use MPLS cloud as the preferred link to reach Paris WAN Edge and use biz-internet as a backup. Which policy configuration must be led in the outbound direction toward Rome to accomplish the task?

NO.160 Refer to the exhibit.

The network team must configure branch B WAN Edge device 103 to establish dynamic full-mesh IPsec tunnels between all colors with branches over MPLS and Internet circuits. The branch ts configured with:


Which configuration meets the requirement?

NO.161 Which protocol is used to measure jitter, loss, and latency on SD-WAN overlay tunnels?

NO.162 What is the behavior of vBond orchestrator?

NO.163 Which protocol is used by the REST API to communicate with network devices in the Cisco SD-WAN network?

NO.164 Drag and drop the devices from the left onto the correct functions on the right.

NO.165 An engineer must automate certificate signing through Cisco.
Which vManage configuration achieves this task?

NO.166 What are the two functions of vSmart? (Choose two)

NO.167 Drag and drop the alarm slates from the left onto the corresponding alarm descriptions on the right.

NO.168 When a WAN Edge device joins the SD-WAN overlay, which Cisco SD-WAN components orchestrates the connection between the WAN Edge device and a vSmart controller?

NO.169 Drag and Drop Question
Drag and drop the components from the left onto the corresponding Cisco NFV infrastructure Building Blocks on the right. Not all options are used.

NO.170

Refer to the exhibit An engineer is configuring a QoS policy to shape traffic for VLAN 100 on a subinterface Which policy configuration accomplishes the task?

NO.171 What is a benefit of using REST APIs?

NO.172 How many network interface cards are needed to add in virtual machine settings when installing vSmart controller on VMware vSphere ESXi Hypervisor software?

NO.173 Refer to the exhibit.

Which shaping-rate does the engineer use to shape traffic at 9 Mbps?