[May-2022] 201 Braindumps – 201 Questions to Get Better Grades [Q120-Q139]

admin May 4, 2022 0 Comments

4.3/5 - (3 votes)

[May-2022] 201 Braindumps – 201 Questions to Get Better Grades

201 Exam Dumps – Try Best 201 Exam Questions – VCEDumps

NEW QUESTION 120
A BIG-IP Administrator needs to restore an encrypted UCS archive from the command line using the TMSH utility.
Which TMSH command should the BIG-IP Administrator use to accomplish this?

load/sys ucs <filepath> passphrase <password>

load/sys config file <filepath> passphrase <password>

load/sys config file <filepath>

load/sys ucs <filepath> no-license

NEW QUESTION 121
Refer to the exhibit.

Which two pool members should be chosen for a new connection? (Choose two.)

172.16.15.9.80

172.16.15.4.80

172.10.15.2.80

172.16.15.1.80

172.16.15.7.80

NEW QUESTION 122
Refer to the exhibit.

A BIG-IP Administrator creates a new Virtual Server. The end user is unable to access the page. During troubleshooting, the administrator learns that the connection between the BIG-IP system and server is NOT set up correctly.
What should the administrator do to solve this issue?

Disable Address Translation

Set Address Translation to Auto Map, configure a SNAT pool, and have pool members in the same subnet of the servers

Set Address Translation to SNAT and configure a specific translation address

Set Address Translation to SNAT and have self-IP configured in the same subnet of servers

Explanation
The status of the pool can be seen that the members are all up, indicating that the network from F5 to the server is no problem, so there is no need to configure selfip on the same subnet. The monitor is normal but the access is not normal, you have to consider the problem of snat, you can configure automap or configure snat and specify snat ip.

NEW QUESTION 123
The BIG-IP appliance fails to boot. The BIG-IP Administrator needs to run the End User Diagnostics (EUD) utility to collect data to send to F5 Support.
Where can the BIG-IP Administrator access this utility?

Console Port

Internal VLAN interface

External VLAN interface

Management Port

NEW QUESTION 124
Which three methods can be used for initial access to a BIGElIP system. (Choose three.)

CLI access to the serial console port

SSH access to the management port

SSH access to any of the switch ports

HTTP access to the management port

HTTP access to any of the switch ports

HTTPS access to the management port

HTTPS access to any of the switch ports

NEW QUESTION 125
Refer to the exhibit
The network team creates a new VLAN on the switches. The BIG-IP Administrator needs to create a configuration on the BIG-IP device. The BIG-IP Administrator creates a new VLAN and Self IP, but the servers on the new VLAN are NOT reachable from the BIG-IP device.
Which action should the BIG-IP Administrators to resolve this issue?

Set Port Lockdown of Set IP to Allow All

Change Auto Last Hop to enabled

Assign a physical interface to the new VLAN

Create a Floating Set IP Address

NEW QUESTION 126
When can a single virtual server be associated with multiple profiles.

Never. Each virtual server has a maximum of one profile.

Often. Profiles work on different layers and combining profiles is common.

Rarely. One combination, using both the TCP and HTTP profile does occur, but it is the exception.

Unlimited. Profiles can work together in any combination to ensure that all traffic types are supported in a given virtual server.

NEW QUESTION 127
Assume a client’s traffic is being processed only by a NAT; no SNAT or virtual server processing takes place. Also assume that the NAT definition specifies a NAT address and an origin address while all other settings are left at their defaults. If the origin server were to initiate traffic via the BIG-IP, What changes, if any, would take place when the BIG-IP processes such packets?

The BIG-IP would drop the request since the traffic didn’t arrive destined to the NAT address.

The source address would not change, but the destination address would be changed to the NAT address.

The source address would be changed to the NAT address and destination address would be left unchanged.

The source address would not change, but the destination address would be changed to a self-IP of the BIG-IP.

NEW QUESTION 128
Which two statements are true about NATs. (Choose two.)

NATs support UDP, TCP, and ICMP traffic.

NATs can be configured with mirroring enabled or disabled.

NATs provide a oneEltoElone mapping between IP addresses.

NATs provide a manyEltoElone mapping between IP addresses.

NEW QUESTION 129
When configuring a Virtual Server to use an iRule with an HTTP_REQUEST event, which lists required steps in a proper order to create all necessary objects.

create profiles, create the iRule, create required pools, create the Virtual Server

create the Virtual Server, create required pools, create the iRule, edit the Virtual Server

create a custom HTTP profile, create required pools, create the Virtual Server, create the iRule

create required pools, create a custom HTTP profile, create the iRule, create the Virtual Server

NEW QUESTION 130
If a client’s browser does not accept cookies, what occurs when the client connects to a virtual server using cookie persistence?

The connection request is not processed.

The connection request is sent to a pology server.

The connection request is loadbalanced to an available pool member.

The connection request is refused and the client is sent a “server not available” message.

NEW QUESTION 131
Which statement accurately describes the difference between two loadbalancing modes specified as “member” and “node”?

There is no difference; the two terms are referenced for backward compatibility purposes.

When the loadbalancing choice references “node”, priority group activation is unavailable.

Loadbalancing options referencing “nodes” are available only when the pool members are defined for the “any” port.

When the loadbalancing choice references “node”, the addresses’ parameters are used to make the loadbalancing choice rather than the member’s parameters.

NEW QUESTION 132
Refer to the exhibit.

A user notifies the BIG-IP Administrator that http://remote company.com is NOT accessible. Remote access to company resources must be encrypted.
What should the BIG-IP Administrator do to fix the issue?

Change the Listening Port on remote.company.com_vs to Port 80

Add a Pool to the Virtual Server remote.company.com_VS

Add an iRule to remote.company.com_vs to redirect Traffic to HTTPS

Change the Type of the Virtual Server remote.company.com_vs to Forwarding Requiring all traffic to be HTTPS access requires HTTP requests to be redirected directly to HTTPS.

NEW QUESTION 133
A BIG-IP Administrator needs to determine which pool members in a pool have been manually forced offline and are NOT accepting any new traffic. Which status icon indicates this?
A)

B)

C)

D)

Option

NEW QUESTION 134
The incoming client IP address is 205.12.45.52. The last five connections have been sent to members C, D, A, B, B.
The incoming client. IP address is 205.12.45.52. The last five connections have been sent to members C, D, A, B, B.
Given the virtual server and pool definitions and the statistics shown in the graphic, which member will be used for the next connection.

10.10.20.1:80

10.10.20.2:80

10.10.20.3:80

10.10.20.4:80

10.10.20.5:80

NEW QUESTION 135
A BIG-IP Administrator upgrades the BIG-IP LTM to a newer software version. After the administrator reboots into the new volume, the Configuration fails to load. Why is the Configuration failing to load?

The license needs to be reactivated before the upgrade.

The upgrade was performed on the standby unit.

A minimum of at least two reboots is required.

Connectivity to the DNS server failed to be established.

NEW QUESTION 136
A BIG-IP Administrator is performing maintenance on the active BIG-IP device of an HA pair. The BIG-IP Administrator needs to minimize traffic disruptions.
What should the BIG-IP Administrator do to start the maintenance activity?

Reboot the BIG-IP device.

Move resources to a new Traffic Group.

Force the BIG-IP device to standby.

Disable switch ports of the BIG-IP device.

NEW QUESTION 137
Assume a virtual server is configured with a ClientSSL profile. What would the result be if the virtual server’s destination port were not 443.

SSL termination could not be performed if the virtual server’s port was not port
443.

Virtual
servers
with a
ClientSSL
profile
are
always
configured
with a destination port of 443.

As long as client traffic was directed to
the alternate port, the virtual server would work as intended.

Since the virtual server is associated with a ClientSSL profile, it will always process traffic sent to port 443.

NEW QUESTION 138
A BIG-IP Administrator explicitly creates a traffic group on a BIG-IP device.
Which two types of configuration objects can be associated with this traffic group? (Choose two.)

Pool Members

Virtual Addresses

iRules

VLANS

Application Instances

NEW QUESTION 139
A BIG-IP Administrator assigns the default http health monitor to a pool that has three members listening on port 80 When the administrator connects to each pool member via the CURL utility, two of the members respond with a status of 404 Not Found while the third responds with 200 OK. What will the pool show for member availability?

All members offline.

Two members offline and one member online.

Two members online and one member offline.

All members online.

Loading …

F5 201 Exam Syllabus Topics:

Topic	Details
Topic 1	Recognize when a packet capture is needed within the context of a performance issue Perform an End User Diagnostic per F5 documentation and collect the output
Topic 2	Identify the appropriate supporting components and severity levels for an F5 support ticket Identify the current configured state of the pool member
Topic 3	Create and restore a UCS archive under the appropriate circumstances Force an active unit to standby under the appropriate circumstances
Topic 4	Provide quantitative and relevant information appropriate for a given issues Identify a pool member not in the active priority group
Topic 5	Review the Network Map in order to determine the status of objects Identify which modules are licensed and or provisioned

For more info read reference:

F5-201 Official Certification Site

Exam policies and FAQs

Verified 201 exam dumps Q&As with Correct 255 Questions and Answers: https://www.vcedumps.com/201-examcollection.html

Tags: 201 exam questions pdf, 201 latest practice questions download, 201 latest test online, 201 reliable test labs, 201 Training online, 201 valid study guide files, 201 valid test format